Adjustable Black Faux Leather Cat Harness with Quick-Release Buckles

This black faux leather cat harness features an H-style two-strap configuration — a neck loop and a girth loop connected by a dorsal bridge strap — giving cats a secure, escape-resistant fit without choking pressure on the throat. The straps measure approximately 1 cm wide, keeping the profile slim on small-to-medium cats while remaining sturdy enough for active outdoor walks.

Quick-Release Buckle Design

Each connection point uses a silver metal quick-release buckle that snaps open with one hand, so you can put on or remove the harness in seconds — useful when a cat is impatient or squirmy. The buckles are reinforced with silver dome rivets at stress points, visible at the strap junctions, which adds both durability and a clean hardware-forward aesthetic.

• Two silver quick-release buckles — neck and girth, one-hand release
• Silver dome rivets at all major strap junctions for reinforced hold
• D-ring attachment point on the dorsal strap for leash connection
• Smooth inner surface on faux leather reduces friction against short-to-medium fur

Sizing and Fit

The adjustable slides on both the neck and girth loops allow the harness to fit cats with a neck circumference of roughly 18-30 cm and a chest/girth of roughly 28-44 cm, covering most adult cats from slim Siamese builds to broader Maine Coon frames. It is not recommended for very small kittens under 1 kg or cats with exceptionally deep chests, as the fixed dorsal bridge length may cause the girth loop to sit too far back. Always check that two fingers fit between the strap and your cat's body after fastening.

• Neck loop adjustable range: approximately 18-30 cm circumference
• Girth loop adjustable range: approximately 28-44 cm circumference
• Strap width: approximately 1 cm throughout
• Suitable for adult cats roughly 2-6 kg body weight
• Not suitable for kittens under 1 kg or cats with deep barrel chests

Material and Care

The straps are made from black faux leather (PU-coated fabric), which is animal-free and wipes clean easily. The hardware is silver-tone zinc alloy — lightweight but firm under normal leash tension. Because faux leather can stiffen or crack if soaked repeatedly, wipe with a damp cloth rather than submerging, and allow to air-dry away from direct heat. Avoid leaving the harness on an unsupervised cat for extended periods, as with any pet harness.

• Body: black PU faux leather, smooth finish, approximately 1 cm wide straps
• Hardware: silver-tone zinc alloy quick-release buckles and dome rivets
• Clean with a damp cloth; do not machine wash or soak
• Air-dry only; avoid direct sunlight or radiator heat to prevent strap stiffening

How to Use Outdoors

Attach a standard 4-6 mm clip leash to the dorsal D-ring before heading outside — the leash attachment point sits between the shoulder blades, distributing pull force across the girth strap rather than the neck. For a cat's first outdoor session, fit the harness indoors for short 10-15 minute periods so the cat can adjust to the sensation before connecting a leash. The black coloring works well for urban garden walks, patio supervision, or controlled outdoor exploration where a discreet, stylish look complements your cat's natural coat.