Black Harness Thong with O-Ring & Adjustable Straps

This black faux leather harness thong is built around a central silver O-ring that connects a waistband strap to two adjustable leg straps, creating a layered geometric silhouette from the front. The straps measure approximately 1 cm wide and fasten via four silver metal buckles — two at the hip junction and two on the lower leg bands — so you dial the fit rather than guessing a size.

Strap Configuration & Hardware

The harness uses a three-point strap layout: a horizontal waist band, two diagonal straps descending from the O-ring to the hips, and two independent lower leg straps with individual buckle closures. All hardware is silver-tone metal — riveted O-ring connector and slide-through buckles — with no exposed raw edges on the strap tips.

• Central silver O-ring diameter approximately 3 cm, riveted at the strap junction
• Four silver metal buckles for independent waist and leg adjustment
• Strap width approximately 1 cm — delicate profile, visible under sheer layers
• Lower leg straps are a separate, detachable piece that buckles onto the main frame
• No fabric panel — straps only, for a fully open back and front aesthetic

Evening & Festival Styling

The waist harness sits just below the natural waist and reads as an accessory layer over high-waist briefs or a swimsuit bottom for a festival-ready strappy harness look. For a evening aesthetic, wear it solo against bare skin — the geometric negative space created by the O-ring center is the focal point. It also layers cleanly over a bodysuit when worn as a belt-style waist accent.

• Worn over high-waist briefs for a layered festival outfit
• Solo against bare skin for an intimate evening session or editorial shoot
• Over a black bodysuit to add structural detail at the waist
• Pairs with strappy sandals and a sheer kimono for a party look

Sizing & Fit Details

The waistband adjusts via the two hip buckles to fit waist circumferences from approximately 60 cm to 90 cm; the leg straps adjust independently for thigh circumferences from roughly 45 cm to 65 cm. Riders with waists above 90 cm may find the strap tension limiting — the straps do not extend further than the buckle allows. The design fits XS through XL comfortably; plus-size wearers should measure first and compare to the upper adjustment limit.

Material & Care

Straps are faux leather (PU) — smooth matte black surface with a slight sheen on the outer face and a thin textile backing on the inner face, which reduces skin friction during extended wear. Hardware is zinc-alloy with a silver-tone plating. To clean, wipe the faux leather with a damp cloth only — do not submerge, machine wash, or tumble dry, as water penetration at the rivets can loosen the hardware bond over time. Store flat or loosely coiled to prevent permanent strap creasing.