Cage Harness with X-Chest Detail & Garters

This black faux leather cage harness is built around a geometric X-chest strap configuration that splits across both sides of the chest, feeding into a diamond-lattice cage body secured at every intersection by silver O-rings. Two adjustable garter straps hang from the waistband's lower O-rings, terminating in metal clips — a detail that bridges harness bra aesthetics with vintage suspender styling.

Chest & Cage Construction

The upper section runs two shoulder straps down to a central horizontal band, where the X-detail creates four distinct strap angles rather than the standard two-strap underbust layout. Below the chest, the straps form two overlapping diamond shapes, each approximately 12 cm across, connected by silver O-rings at the top, sides, and base. Every junction uses a visible silver rivet for reinforcement, keeping the geometry clean under movement.

• X-chest strap pattern with four directional angles across the sternum
• Diamond cage panels spanning approximately 24 cm of torso coverage
• Silver O-rings at all strap intersections — smooth chrome finish
• Flat faux leather straps approximately 1.5 cm wide throughout
• Garter clips with metal hardware, adjustable drop length via slider buckles

Festival & Evening Styling

Worn over a sheer black bodysuit, the harness functions as a structured chest accessory for festival fashion. Layered under an open blazer with high-waist trousers, the garter straps create a vertical line that suits editorial evening looks. The cage panels sit flush against the ribcage — not designed to provide lift or support, so a strapless bra or pasties worn underneath keep coverage intact while maintaining the open-cage visual.

• Festival outfit: over mesh crop top, paired with high-waist shorts
• Evening aesthetic: worn alone as intimate fashion layering piece
• Party look: under open-front blazer with the garters visible below the hem
• Garters can be unclipped and tucked for a cleaner above-waist silhouette

Sizing & Strap Fit

The shoulder and chest straps adjust via metal sliders across a range of approximately 20 cm per strap, making the harness suitable for busts measuring roughly 75 cm to 105 cm around and torso lengths from 30 cm to 45 cm shoulder-to-waist. The garter straps extend approximately 25 cm from the waistband O-rings to the clips. This design sits best on straight-to-hourglass torso shapes; a very short torso (under 28 cm shoulder-to-waist) may find the diamond panels stack too close together. Measure your underbust and torso length before ordering.

Faux Leather Material & Care

The straps are cut from smooth faux leather (PU-coated fabric) — vegan leather with no animal-derived components. The material holds its shape well against body heat but should not be machine washed. Wipe clean with a damp cloth and mild soap, then air dry flat away from direct sunlight. Avoid prolonged contact with moisture, as PU material can delaminate at seams after repeated soaking. Hardware is silver-tone zinc alloy; dry immediately after any contact with water to prevent surface oxidation.