Crisscross Cage Harness with White Reflective Straps and Choker

This white reflective crisscross cage harness uses an X-pattern of straps across the chest, a fitted choker collar linked by a short chain, and a single drop strap that hangs from the waist belt down one thigh. The straps carry a reflective coated finish that lights up bright white under camera flash and direct light, while reading as an off-white matte tone in normal room lighting. Metal grommets sit at each strap intersection, holding the diamond cage shape in place over a bodysuit or bare skin. The choker itself closes with its own small buckle at the back of the neck, separate from the chest buckle, so the collar fit and the chest fit can be adjusted independently.

Crisscross Cage Construction

The chest cage is built from crisscrossing straps that intersect at diagonal points, each junction reinforced with a silver-toned metal grommet roughly 1 cm across. A separate choker collar sits at the neck and connects to the cage through a fine metal chain, so the harness reads as one continuous piece rather than a top plus a collar sold apart.

• Diagonal crisscross straps form a diamond cage over the chest and ribs
• Choker collar joined to the cage by a short metal chain
• Adjustable buckle at the back for a customized chest fit
• Single drop strap runs from the waist belt down the front of one thigh

Styling & Occasion

Layer the harness over a black bodysuit for a rave or festival look, where the reflective straps catch stage lighting and camera flash from across a room. For a photoshoot or costume set, wear it over sheer black tights with heels so the white straps stand out against the dark base layer; it also sits well pulled over a fitted black slip dress for a going-out look that stays subtle in ambient light and lights up only when flash hits it. Outside of nightlife use, the same harness works layered over a fitted black turtleneck for an editorial shoot, since the straps photograph as a bright graphic outline against dark fabric.

Sizing & Fit

The harness comes in six labeled sizes, from XS/S up to 6XL/7XL, and each strap buckle adjusts within its labeled size rather than across sizes. XS/S and S/M suit slimmer chest and waist measurements, L/XL covers the middle range, and 2XL/3XL through 6XL/7XL extend the strap length for fuller frames. Buyers between two labels should size up, since the buckle range is narrow enough that an undersized harness will pull tight across the grommets and mark the skin. Very petite frames below the XS/S range or frames larger than the 6XL/7XL strap length are not covered by this size run, so checking a personal chest and waist measurement against the label before ordering is worth the extra minute.

• XS/S
• S/M
• L/XL
• 2XL/3XL
• 4XL/5XL
• 6XL/7XL

Material & Care

The straps and cage are cut from faux leather webbing with a reflective coating bonded to the strap face rather than woven through it. Wipe the reflective surface with a damp cloth instead of machine washing, since repeated washing can dull the coating over time; hand wash gently in cold water only if needed and air dry flat, never in a dryer or on a radiator. The trade-off of a coated reflective finish is that it is less flexible than plain faux leather, so the straps hold their shape well but should not be folded sharply for long-term storage. Rolling the harness instead of folding it keeps the reflective coating from creasing at the grommet points.

• Material: faux leather webbing with a reflective coated finish
• Hardware: silver-toned metal grommets and an adjustable buckle
• Care: wipe clean or hand wash cold, air dry flat only