Reflective White Choker Harness Set with O-Ring and Waist Cage

This two-piece reflective white harness set pairs a radial chest cage with a triangular waist harness, both cut from faux leather strapping and finished with a reflective coating along every edge. The chest piece starts at an adjustable choker collar and fans out into six straps that meet at a single metal O-ring below the sternum, while the waist piece crosses the hips and front in a triangle shape anchored by its own ring and buckle set. Under direct light the strap edges throw back a bright white line, while in normal room lighting the set reads as a clean white harness against skin or dark clothing.

Chest Cage Construction

The chest harness opens at the back of the neck with an adjustable choker collar, then splits into six straps arranged in a star pattern that converge on a center O-ring positioned just under the bust line. Small metal grommet eyelets sit at every strap junction, reinforcing the points where the straps cross rather than relying on stitching alone. Because the collar and the two shoulder straps each carry a separate buckle, the cage can be tightened at the neck without changing how loosely or tightly the star pattern sits across the chest.

• Adjustable choker collar strap with a rear metal buckle
• Six radial straps converging at a center O-ring connector
• Grommet eyelet hardware reinforcing every strap intersection point

Waist Harness Detail

The second piece sits lower, crossing the hip line with straps that form a triangle over the front and buckle at both sides for a fit that can be adjusted independently of the chest piece. A metal ring anchors the point of the triangle, echoing the O-ring used on the chest harness above it. Worn together the two pieces read as one continuous set, but each buckles and unbuckles on its own, so either piece can be worn without the other over a bra top, bodysuit, or bikini bottom.

How to Style It

Worn as a matching set over a black bralette and high-waisted briefs, the harness works as standalone eveningwear for a themed party, festival look, or photoshoot where the radial strap pattern is meant to be seen in full. Layered under an open blazer or an oversized sheer shirt with only the choker collar and chest straps left visible, the same chest harness shifts toward a going-out top for a club night, while the waist piece stays hidden or gets left off entirely for that look.

Sizing and Fit

This set comes in six labeled sizes running XS/S, S/M, L/XL, 2XL/3XL, 4XL/5XL and 6XL/7XL, covering frames from a smaller build at the XS/S end up to a fuller build at 6XL/7XL. The buckles at the collar, chest straps, and waist adjust further within each labeled size, so someone near the edge of a size range can fine-tune the fit rather than needing to size up or down. A very petite frame under the XS/S range or a frame beyond the 6XL/7XL range will not get full adjustment room from the buckles alone.

• XS/S and S/M suit slimmer chest and hip measurements
• L/XL and 2XL/3XL cover mid-range chest and waist sizes
• 4XL/5XL and 6XL/7XL extend the straps for fuller frames

Material and Care

Both pieces are built from faux leather straps roughly 2 cm wide with matte metal grommets, buckles, and connector rings, plus a reflective strip bonded along the outer edge of each strap. The reflective finish is decorative rather than a certified high-visibility coating, so it should not be relied on as safety gear for roadside or trail use after dark. Wipe the straps down with a damp cloth to clean them, keep the set away from direct heat sources, and skip the washing machine, since agitation can lift the reflective bonding away from the strap surface over time.