Y-Neck Diamond Cage Body Harness in White Reflective Strap

This body harness sets a Y-strap neckline that splits into a symmetric diamond cage across the ribcage, held together at each junction by silver-tone eyelets. The strap itself is finished in a white reflective material that reads as a pale strap in daylight and flashes bright white under camera flash or headlights. It is built as a standalone strap piece, meant to sit over a crop top, bralette or bare skin depending on the look you want, and the flat, non-elastic straps hold their shape rather than twisting during wear.

Diamond Cage Construction

The Y-strap starts at the back of the neck, meets at the collarbone, then fans into vertical straps that cross into a diamond lattice over the ribcage. Each crossing point is fixed with a small silver-tone eyelet, so the cage holds its shape instead of shifting during wear. The lattice sits symmetrically down the front of the torso, leaving open gaps between straps rather than covering the ribcage as solid fabric would.

• Y-strap neckline splits into a multi-strap diamond cage over the ribcage
• Silver-tone eyelets fix every strap junction for a stable lattice shape
• Strap width runs approximately 1.2cm, non-elastic and non-stretch
• Adjustable buckle closure sits at the side for a closer or looser hold

Night-Out Layering Looks

Worn over a black cropped top and high-waisted leggings, the diamond cage reads as a structured accessory layer rather than the outfit itself. Paired instead with a fitted slip dress, the white reflective strap becomes the visual focus against solid dark fabric, especially under club lighting or flash photography. Because the strap has no lining or padding, it stays flat and lightweight enough to layer under an open jacket without adding bulk at the shoulders.

• Over a black crop top and leggings for a rave or festival outfit
• Over a fitted slip dress for a going-out look with visible strap detail
• Layered over a plain bralette for a minimal, strap-forward silhouette

Sizing & Fit

The harness is offered in six labeled sizes: XS/S, S/M, L/XL, 2XL/3XL, 4XL/5XL and 6XL/7XL. XS/S runs smallest through the range up to 6XL/7XL at the largest, with the four labels in between scaling in steps across that span. The buckle closure fine-tunes tension within your chosen label; it does not stretch far enough to bridge two labels, so picking the closest size first gives the most accurate fit. Because the diamond cage leaves open gaps between straps, it does not function as full coverage and is not meant to replace a top on its own.

• XS/S and S/M suit slimmer, narrower ribcages
• L/XL sits in the middle of the size run for average frames
• 2XL/3XL through 6XL/7XL extend strap length for fuller figures

Material & Care

The strap is made from a white reflective faux leather, unlined and non-stretch, finished with silver-tone metal eyelets at each junction and buckle point. Wipe the strap surface clean with a damp cloth rather than machine washing it, since repeated washing can dull the reflective coating over time.

• White reflective faux leather strap, approximately 1.2cm wide
• Silver-tone metal eyelets and buckle hardware at adjustment points
• Unlined single-layer strap construction, non-stretch
• Spot-clean only; avoid machine washing to protect the reflective finish